![]() The Upload button will be highlighted while the data is being sent to the SmartScope. When you're done, hit the 'Upload' button, which will transfer the data to the SmartScope the AWG output. The AWG is configurable within these limits:ģ.3V (max amplitude will decrease accordingly!) You have to use the 'Upload function' button and check the Analog checkbox to activate the output (see further). NOTE: At this point the AWG output is not yet active. TIP: Double-tapping the value will bring up the Numpad, which makes it much easier to specify accurate values Next, open up the Analog submenu and select the type of predefined waveform you want the AWG to generate:Ĭonfigure the amplitude, offset and frequency of the wave to be generated. In order to do so, first open up the main menu by tapping on the LabNation logo at the bottom-left of the screen, and expand the Generator menu. You can define your own waveforms (see below), or you can use one of the built-in signals which have been predefined in the SmartScope app. In the image above, you can see the AWG pin is surrounded by 2 ground pins, either of which you can use to connect to the other device.Ĭonfiguring the AWG using pre-defined waves The ground, so both devices have the same reference voltage.Please keep in mind that you always should bridge 2 wires between 2 separate devices. ![]() The signal generated by the AWG is presented on the 3rd-left pin on the bottom row of the AUX connector, as shown in the following image: 3.2 Define arbitraty waveform in Excel (.csv file upload).2 Configuring the AWG using pre-defined waves.
0 Comments
Leave a Reply. |